Bảng Mạch Mở Rộng L293D Mega Uno Duemilanove
3 Đánh Giá
4 Đã Bán
50
35.200 đ
Xem sản phẩm trên ShopeeQuốc tế
chủ nhật 21/11/2021 lúc 10:40 CH
New Motor Drive Shield Expansion Board L293D Mega UNO Duemilanove
Item Details:
* L293D Motor Drive Expansion Shield Board Module For Arduino Duemilanove Mega
* 100% brand new and high quality
* Made of high quality material, durable and practical to use
* L293D is a monolithic integrated, high voltage, high current, 4-channel driver. Basically this means that the chip can be used with DC motors and power supplies up to 36 volts, which are some fairly large motors that can provide maximum The current is 600mA per channel, and the L293D chip is also a so-called H-bridge. The H-bridge is usually a circuit that enables the load to be applied to the load in either direction, such as an output.
* 2 interfaces for 5V servo are connected to high resolution dedicated timer - no jitter!
* Can drive 4 DC motors or 2 stepper motors or 2 servo motors
* Up to 4 bidirectional DC motors with independent 8-bit speed selection
* Up to 2 stepper motors (unipolar or bipolar) with single coil, double coil or staggered stepping.
* 4 H-bridges: 0.6A (1.2A peak current) and thermal protection per bridge, which can run motors from 4.5V to 36V DC
* Pull-down resistor disables motor during power-up
* With reset button
* 2 external terminal power connectors for separate logic/motor power supplies
* Tested to be compatible for Mega, for Diecimila and for Duemilaove
Item Details:
* L293D Motor Drive Expansion Shield Board Module For Arduino Duemilanove Mega
* 100% brand new and high quality
* Made of high quality material, durable and practical to use
* L293D is a monolithic integrated, high voltage, high current, 4-channel driver. Basically this means that the chip can be used with DC motors and power supplies up to 36 volts, which are some fairly large motors that can provide maximum The current is 600mA per channel, and the L293D chip is also a so-called H-bridge. The H-bridge is usually a circuit that enables the load to be applied to the load in either direction, such as an output.
* 2 interfaces for 5V servo are connected to high resolution dedicated timer - no jitter!
* Can drive 4 DC motors or 2 stepper motors or 2 servo motors
* Up to 4 bidirectional DC motors with independent 8-bit speed selection
* Up to 2 stepper motors (unipolar or bipolar) with single coil, double coil or staggered stepping.
* 4 H-bridges: 0.6A (1.2A peak current) and thermal protection per bridge, which can run motors from 4.5V to 36V DC
* Pull-down resistor disables motor during power-up
* With reset button
* 2 external terminal power connectors for separate logic/motor power supplies
* Tested to be compatible for Mega, for Diecimila and for Duemilaove